Microscan MS-4X Manual de usuario descargar pdf (Pagina 14)

1-6 MS-Connect 210 User’s Manual

Connect the System

Connecting a 5-Volt Reader to the MS-Connect 210

If you are using an MS-3, MS-3 CCD, MS-4, Quadrus MINI, or Quadrus MINI 3:

1. Attach the 19-pin to 15-pin Reader Cable (P/N 61-000127-01) to the MS-Connect 210

via the 19-pin reader connector, shown in the illustration below.

Tighten the cable housing at the 19-pin reader connector on the back of the MS-Connect

210 unit.

3. Attach the 15-pin end of the Reader Cable to the 10-28VDC end of the IC-332 Power

Adapter, and attach the reader’s cable to the 5VDC end of the IC-332 Adapter.

Important: Reversing the IC-332 in this configuration may seriously damage the

interface.

4. Attach cabling inside the wiring box.

Attach an Object Detector (optional) to the MS-Connect 210 via the trigger

Micro-Change

connector, shown in the illustration below.

Attach the Power Supply to the MS-Connect 210 via the power Micro-Change connector,

shown in the illustration below.

CAUTION: Be sure that all cables are connected BEFORE applying power to

the system. Always power down BEFORE disconnecting any cables.

19-pin Reader

Connector

Trigger Micro-Change

Connector

Power Micro-Change

Connector

Large CGB

accomodates

RJ45 Ethernet

connector

MS-Connect 210 Connectors

CGBs

8-pin M12 Industrial Ethernet Micro-Change Connector (optional)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Sin comentarios

Microscan MS-4X Manual de usuario Pagina 14