Microscan MS-2 Manual de usuario descargar pdf (Pagina 96)

7-8 MS-2 CCD Reader User’s Manual

Default/Reset/Save

Understanding and controlling your reader’s active, saved, and default settings is critical to

its successful operation.

Reset

Reset (“A” command) affects only current settings (active memory) and does not save for

power-on.

Save for Power-On

Power-on parameters (“

” commands) are saved, recalled, and loaded into current parameters

when power is cycled to the reader.

Important: The following commands must be followed by a <Z> to be saved for power-on:

Host Protocol, Baud Rate, Data Bits, Stop Bits, Parity, Trigger Characters (Delimited,

Start, Stop), Preamble, Postamble, and No Read Message.

All other parameters are saved for power-on without a <Z>. However, a <Zrd> affects all

parameters.

Function Serial Cmd

ESP (first, right-click in any

menu tree)

a. When you right-click in a menu tree and select Default Current Menu Settings or Default

All ESP Settings, it is important to note that only ESP settings are defaulted. To save these

defaults to the reader itself, you need to follow up with a Save to Reader, Send and Save

command.

Reset

(not saved

for power-on)

Reset <A>

Save to Reader,

Send No Save

Save for Power-on

Save Current Settings for Power-On <Z>

Save to Reader,

Send and Save

Recall Microscan Default Parameters

and

Save for Power-On

<Zrd> No

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 124 125

Sin comentarios

Microscan MS-2 Manual de usuario Pagina 96