Microscan MS-Q Imager Manual de usuario descargar pdf (Pagina 10)

Warning and Caution Summary

The MS-Q can be set to use targeting lasers. If the targeting lasers

are activated, do not stare into the beams. The MS-Q’s targeting

lasers have been rated as Class 2 Lasers by ANSI 2136.1-1993.

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installa-

tion. This equipment generates, uses, and can radiate radio frequency energy, and,

if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of controls, adjustments, or performance of procedures other than those

specified herein may result in hazardous laser light radiation exposure.

The laser beam can be harmful to eyesight. Avoid eye contact with the laser

beam. Never point the beam at other people, or in a direction where people

may be passing.

There are no user serviceable parts in the reader. Opening the reader voids the

Microscan Systems warranty and could expose the user to laser diode power of

up to 7mW.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 203 204

Sin comentarios

Microscan MS-Q Imager Manual de usuario Pagina 10