Microscan MS-Q Imager Manual de usuario descargar pdf (Pagina 36)

Practice Targeting

Step 1 — Practice Targeting

When first connecting, allow approximately 3 seconds for the MS-Q to initialize.

1. Hold the Imager steady and point at a bar code

symbol between 2.75 and 4.5 inches (70 to 114

mm) away (High Resolution Option) or between 4

inches

and

inches (

102

229

mm) away (Standard

Resolution Option).

2. Squeeze and hold the red trigger.

3. A red targeting spot will appear in front of the

Imager surrounded by a flashing RED LED pattern.

4. Center the laser spot on the symbol and wait a second

or two for a decode.

For configuration symbols, you will hear 2 beeps when a good read occurs. For

data symbols, you will hear 1 beep when a good read occurs.

5. If no decode occurs, slowly draw away from the symbol while holding the spot

steadily in place.

Read this Test Symbol:

Tips for Reading

• Typically, you should not hold the Imager exactly perpendicular to the symbol.

Position the Imager about 15 to 30 degrees to avoid specular reflection.

• Do not wave the Imager about or attempt to sweep across a symbol; sudden

movements will create fuzzy images and result in failed read attempts.

• The Imager is omnidirectional and can read a symbol from any position (The exception

to this is where you have enabled the read zone for certain linear symbols; in this case,

the read area will be oriented to the length of the symbol.)

The laser beam can be harmful to eyesight. Avoid eye contact with the

laser beam. Never point the beam at other people, or in a direction

where people may be passing.

ABCDEFGHIJKLMNOP

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 203 204

Sin comentarios

Microscan MS-Q Imager Manual de usuario Pagina 36