Microscan MS-Q Imager Manual de usuario descargar pdf (Pagina 59)

Bluetooth

Save changes whenever you reconfigure Imager settings.

Save

Settings

Clear

all Data

Default

to USB

Clear XML

Rules

Default

to PS2

Bluetooth Access

In the default access mode (Private Access) only one Imager can access the modem,

provided that the Imager remains active.

However, more than one Bluetooth Imager can connect and automatically transmit to a

single host modem, provided that each Imager has been setup for communication with

a Bluetooth modem and Shared Access in enabled for each.

Private Access

When Private Access is enabled (default), only one active and

connected Bluetooth Imager will be able to send data. An Imager

remains active if it is connected and has not reached the timeout

period set in Sleep Mode Timeout. If it enters Sleep Mode, any

other Imager enabled for Private Access can become active and

maintain exclusive access as long as it remains active itself.

Shared Access

When Shared Access is enabled, an Imager will disconnect from

the host after a successful send and re-connect only when it has

new data to send and the host port is available. In this mode any

Imager can send data, but since an Imager must identify itself

each time it connects, a few seconds of latency will necessarily

occur before each transmission. This however does not prevent the

Imager from reading and decoding while awaiting access.

All Imagers must have Shared Access enabled before the mode can function in

any of the Imagers individually.

Shared Access is recommended only when RF Two-Way Mode is enabled.

Private (default)

Shared Access

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 203 204

Sin comentarios

Microscan MS-Q Imager Manual de usuario Pagina 59