Microscan Quadrus EZ Manual de usuario descargar pdf (Pagina 298)

15-4 Quadrus EZ Reader User’s Manual

Assigning a Network Address

This procedure will configure the reader to work with the TCP/IP configuration of the host

computer.

Note: This is only a temporary solution since the preferred method is to receive IP, subnet,

and gateway (if necessary) from your IS department.

If an IP address has been assigned to the reader by the IS department (the most appropriate

method), skip steps 1-3 below.

1. Determine the host computer's IP address on the host's network:

Go to the Windows Start menu, select Run, type command and press Enter.

a) On Win2K computers, at the command prompt, type ipconfig.

b) On Win98 computers type winipcfg and select the Ethernet Interface in the

drop-down box.

2. To the IP Address of the host computer add '1' to the last decimal value. This will be

the IP address that you will assign to the reader.

For example, if the host computer's IP is 123.234.1.25, the reader's IP will be

123.234.1.26.

3. To verify that the new IP address is available, go back to the command prompt and

type in the command: ping [reader IP address]. For example: ping 123.234.1.26.

If the ping program responds with “Request timed out” message, then the IP

address can probably be used temporarily. If you get a “Reply” message, then that

address has already been assigned to another device and you need to contact your

IS department for an available IP address.

4. Do Receive Reader Settings.

5. From the ESP Communications menu, enter your reader's new IP address, for

example, 123.234.1.26, and save this to the reader.

The reader is now configured with an

IP address that will allow communica-

tion with the host computer. In the ESP

Communications menu, you should

see the following:

6. Go to Step 3, Communicating in

Ethernet.

1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 365 366

Sin comentarios

Microscan Quadrus EZ Manual de usuario Pagina 298