Microscan Quadrus EZ Manual de usuario descargar pdf (Pagina 64)

3-10 Quadrus EZ Reader User’s Manual

Trigger

External Trigger Edge

Important: Level and Edge apply to the active logic state (Active Off (I

OFF

) or Active On

)) that exists while the object is in a read cycle, between the rising edge and falling

edge. Rising edge is the trigger signal associated with the appearance of an object. Falling

edge is the trigger signal associated with the subsequent disappearance of the object.

Usage:

This mode is highly recommended in any application where conveying

speed is constant or if spacing, object size, or timeouts are consistent.

Definition:

External Trigger Edge, as with Level, allows the read cycle (active state) to

begin when a trigger (change of state) from an external sensing device is

received. However, the passing of an object out of sensor range does not end

the read cycle. The read cycle ends with a good read output or, depending on

End of Read Cycle setting, a timeout or new trigger occurs.

Serial Cmd: <K200,3>

Trigger Edge

Initiate Read Cycle:

Object # 1, moving in front of the detector beam,

causes a change in the trigger state, initiating the

read cycle.

Initiate Second Read Cycle:

Object # 2, moving in front of the detector beam,

causes another change in the trigger state. This

signal initiates a new read cycle and ends the pre-

vious read cycle unless Timeout is enabled and a

good read or timeout has not occurred.

Associated waveforms assume

External Trigger State is set to

Active On.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 365 366

Sin comentarios

Microscan Quadrus EZ Manual de usuario Pagina 64