Microscan EZ Match Imager Manual de usuario descargar pdf (Pagina 217)

100

101

EZ Match User Manual

8-33

I/O Parameters

Output State

Pulse Width

Output Mode

Pulse

This is the default mode of operation in which the programmable output is activated when

the Output On condition has been met and held active for the duration of the selected

pulse width.

Latch Mode 2 (Unlatch Opposite Condition)

The programmable output is activated when the Output On condition has been met and

held active until the opposite condition selected under Output On has been met.

For example, if No Read is enabled under Output On, the programmable output will go

active on a No Read and remain active until the opposite condition, a Good Read, occurs.

Latch Mode 3 (Unlatch Re-enter Read Cycle)

The programmable output is active when the Output On condition has been met and is

held active until a new read cycle begins.

Note: All of the Output On modes are inhibited when any Output on Warning is active

for Output 1.

Definition: Sets the active electrical state of the discrete output.

Serial Cmd:

K810,

output on,

output state

,pulse width,output mode>

Default: Negative

Options: 0 = Negative 1 = Positive

Definition: Sets the time in 10 ms increments that the discrete output remains active.

Serial Cmd:

K810,

output on,output state,

pulse width

,output mode>

Default: 5 (50 ms)

Options: 0 to 255 (0 to 2.55 seconds). Divide the number entered on the command

line by 100 for time in seconds.

Definition: Sets the condition in which the discrete output is de-activated.

Serial Cmd:

K810,

output on,output state,pulse width,

output mode

Default: Pulse

Options: 0 = Pulse

2 = Latch Mode 2

3 = Latch Mode 3

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 430 431

Comentarios a estos manuales

Sin comentarios

Microscan EZ Match Imager Manual de usuario Pagina 217

Comentarios a estos manuales

Relacionado con productos y manuales para Lectores De Códigos De Barras Microscan EZ Match Imager